Method is: the line output transformer core insulated wire around the cold end with a few laps in series with the line deflection coil (ie not connected one end of the line pipe c pole), cold end-to-ground voltage is low, you can reduce the winding insulation requirements of the new Canadian . After the string into, if the line width exception but heavier, then the second-tier head swap; such as the line width correction amount is inappropriate, may increase or decrease the number of coil turns. Before the above process, the lines were measured current values ​​should be to prevent the overloading of line pipe therefore, might be able to find other reasons swath exception.uzXservice manual download site