This machine had been struck by lightning light silent, premenstrual maintenance overhaul after the fault. Because this machine belongs to the I2C bus control, had been struck by lightning. Reason may be due to lightning interference and rewrote the preset in the data in the storage caused the failure. Before the maintenance man because of failing to master into a "maintenance" mode and cannot be repaired. So this machine maintenance should from the software. dvuservice manual download site
 dvuservice manual download site
To find information about panasonic MX - 4 machine heart into maintenance mode method: 1. The maintenance way to enter and exit: hold down the "memory" button on the remote control, press the volume again "-" key, enter maintenance mode. White screen for grating at this time. Press the "N" on the remote control key twice, and then out of maintenance mode. 2. The adjustment of data: after into maintenance mode, press the "P" button on the remote control, can be adjusted in turn select projects, according to the volume on the remote control to "+" or "-" button to change the corresponding data of the project. dvuservice manual download site
 dvuservice manual download site
Prepare for data to the remote control and manual adjustment, but the fact is not well, first of all, the problem is in accordance with the "memory" button. Where is the "memory" button? Searched the remote control and manual also see at the end of the word "memories". Finally in the instruction manual "exhale" button, "exhale" and "memory" is the same thing? Further to find all the materials, this button have "breath", "call", "called back", "called back", "recall", "status", "screen breathe out" and so on name, but without the word "memory". Try this button is treated as a "memory" button, the "memory" button on the remote control hold, then press "-" volume key. But the screen.

 3    1 2 3 Next Last