|
5Biservice manual download site
( 10 ) Carefully pry the LCD data display fixed metal frame ( note the direction of the LCD screen to come up with an internal conductive rubber and location , in order to properly replace . Replace To ensure conductive rubber cleaning ) .5Biservice manual download site
( 11 ) Remove the plastic bracket under the LCD data display , then remove the screws loosen the mounting screws underneath the right side behind the flash and the LCD screen , you can lift the viewfinder and AF autofocus module ( note to the whole group removed, so as not to affect the clarity of focus shot ) .5Biservice manual download site
( 12 ) use of the electric soldering iron heat the sub-plate ( Figure 2 ) connected to the respective parts and joints associated with the soft solder wire and disengaged , and then slowly remove the sub-plate .5Biservice manual download site
2 lens and body decomposition5Biservice manual download site
( 1 ) Loosen and remove the retaining screw under the sub-plate contact assemblies DX coding ( 4 ) , remove the DX coding components, shown in Figure 3 .5Biservice manual download site
( 2 ) Loosen and remove the left side of the camera AF screws ( 2 ) on the zoom gear assembly , remove the splint.5Biservice manual download site
( 3 ) Unscrew and remove the lens and the body parts of the deep corners of fixing screws ( 4 ) , and then gently pull out the lens assembly , shown in Figure 4 .5Biservice manual download site
3 Decomposition of the lens components5Biservice manual download site
( 1 ) Unscrew and remove the lens with a soft zone adjacent to the rear corner of a fixed lens positioning positioning iron telescopic fixing screws ( 1 ) , remove the positioning block .5Biservice manual download site
( 2 ) 2,3,4 barrel draw from the first tube , the record start position ready withdrawn .5Biservice manual download site
( 3 ) from the second tube slowly pry out the rear of the shading film, and then out of the third and fourth from the second cylinder barrel .5Biservice manual download site
( 4 ) Using needle-nose pliers carefully pull three sliding guide tube metal nails , you can draw from the 3rd 4th cylinder barrel .5Biservice manual download site
( 5 ) Section 4 cylinder rear clockwise to rotate when you can not , then swing a little bit , pull the mirror group , the shutter assembly to be pulled out from the 4th cylinder , each cylinder and component position shown in Figure 5 . Then stretching band can then use the zoom tool accordingly replaced when replacing the soft shutter assembly to be careful with each small gear , optocouplers and related components , to light, accurate, stable , and to observe , to be determined operation.
3 Home Previous 1 2 3 Next Last |