The camera can play back photos on the memory card, LCD viewfinder is also normal, but when shooting can not be imaged, the subject can not be stored.ymiservice manual download site

Failure Analysis: LCD viewfinder is working properly, you can not image when shooting, the camera is the mechanical part of normal, the fault should be out in the image processing circuit.ymiservice manual download site

Troubleshooting:ymiservice manual download site
(1) Remove the front cover on the left side three screws on the right two screws at the bottom two screws, remove the camera front cover.ymiservice manual download site

(2) After careful examination, did not find a blackened, broken components.ymiservice manual download site

(3) Power-test machine, the flash fires again when you press the shutter, the flash does not work, indicating the existence of the problem of poor contact line, should focus on checking the connection wires.ymiservice manual download site

(4) carefully check the connection wires, cables found a group of serious wear, shown in Figure 2 (This machine is not installed at the factory, causing the cable to be worn).ymiservice manual download site

(5) cable with a knife gently clean the surface of the insulating material, and then welded thin wires will be disconnected good.ymiservice manual download site

(6) mounted on all parts removed.ymiservice manual download site

(7) test machine, everything is normal, troubleshooting.ymiservice manual download site