Panasonic NV - M7 camera LED indicator light flashes after the power supply, soon to power outages, leds put out fault repair methods |
| Time£º2014-05-31 17:13:47 Source£ºNetwork Author£ºUnknown Clicks£º1402 |
|
UAsservice manual download site
But the machine can't enter the camera, press the REC button doesn't work. Video analysis to make the machine into the state, shall meet the two requirements: (1) the REC/PLAY (camera/video reproduction) switch to normal; (2) the wipe off good grounding by mistake. As the both switch can work effectively, and the record shows that the machine has entered the camera state. So, REC can signals into the CPU became the key operation, by scanning the signal channel found that P002 (3) between the foot to 6 foot CPU. Because the machine host thinner, and as the double-sided board, not easy to look up to the breaking point, so connected with wires to (3), 6 end, camera normal operation, comprehensive failure completely ruled out.UAsservice manual download site
2 Home Previous 1 2 |
|