4 The camera which wires are short and rather special , was soft ribbon . I hand no such wire , then consider using instead of the four wires soldered directly .

 

5 . Looking for a small transformer and open , use one of a group of smaller , whichever is longer than 1 ~ 2cm long wire damage enameled four , the two ends of the line to paint and lining of tin and set aside.

 

6 . Use of waste heat will damage the next iron wire welding and clean with alcohol here , with one end connected to the solenoid cut with scissors directly from the roots , to connect with the stand of the four corresponding solder wire . Then carefully check to make sure the correct welding wire , and then each part by the reverse order of removal Replace the test machine , the camera returns to normal.