( 2 ) Remove the fixing screws and associated shutter button next to the LCD screen beside the screws , remove the right of the camera strap to loosen the fixed iron screws loosen remove the camera 's AF illuminator reflector fixing screws and carefully flips soft flexible LCD panel assembly .

 

( 3 ) Carefully tear on the left door switch brush flexible circuit board , loosen remove the circuit board contacts dx detection code fixing screws .

 

( 4 ) Remove the bottom of the camera , loosen the fixing screws small body and small body next to the eyepiece fixing screws , with special attention to the right of flexible plate below一枚small body hidden fixing screws must be removed.

 

( 5 ) the use of waste heat from electric iron on the lower right side of the top four wire welding roof pentaprism next .

 

( 6 ) In particular, when the size of the principal decomposition careful not to pull off the flexible circuit board and the associated wiring , after decomposition of the size of the subject steel shutter curtain can be replaced and cleaned. If no eos888 Original steel shutter curtain , available Ricoh 2000 camera shutter steel curtain substitution, if the original steel curtain mild deformation , which can be caught in a book , and then add the heavy pressure for some time, recoverable use , attention must not beat with a hammer .

 

3 Install Recovery

 

(1 ) on the shutter to be a good replacement of small body , followed by recovery procedures , attention eos888 Canon AF SLR camera with the general manual focus SLR camera equipped with a difference in the Canon eos888 want a small reflective body in the assembly turn the mirror is in the state assembly, or can not work properly.

 

( 2 ) Replace the size of the body , the wires and install the parts removed in reverse order of removal during installation.

 3   Home Previous 1 2 3 Next Last