Sharp Video machine (PN200/300/500/C10 etc. ) cleared lamp time , press and hold standby, "volume down " + " to select the next ", after the boot.

Sharp 100S/00X/200/220 etc. , projector bulbs clear method , press standby -, +, AUTOSYNC three key boot .

Note : SHARP back out of the machine ( 2004 new ) do not arbitrarily cleared, cleared to zero , then we should replace the bulb , or the light will be fried in about 200 hours .

 

Panasonic projector clear method : press the "MENU" to find the lamp time, press "ENTER" three seconds , appears "POWER OFF" , turn off the power to restart OK!

 

Hitachi ( Hitachi ) projector clear method

 

Hitachi projector clear method : boot , press the RESET Jian 3 seconds, the time the dialogue appears , select 0 to OK .

 

SONY ( Sony ) projector clear method

 

Sony clear method : RESES + Left + Right + OK (for most Sony models )

 

NEC ( Xinhua ) projector clear method

 

830/840/850/440 series , then there will be time to two indicator lights , including the LAMP indicator , clear method under the remote control standby OFF Kin about 20 seconds , at the bottom of the remote control has a headphone jack , if the cable the words can be connected to the projector's remote control input port , so it will facilitate cleared a little .

 

3M projector clear method

 

Hitachi OEM clear method : in the boot , press RESET Kin 3 seconds , there will be a time to have a conversation , select 0 just fine.

 

Mitsubishi ( Mitsubishi ) projector clear method

 

Mitsubishi projector clear method : Left + Right + power in standby under .

 3    1 2 3 Next Last