|
Projector With its unique presentation projection capabilities, research and education has become one of the devices , business meetings and conferences as required. But because the projector is expensive, many users are not many opportunities to touch it , to the knowledge of all aspects of the projector awareness are relatively limited, so there will inevitably be a variety of problems during operation , following the author of some of the common but confusing question was answered.FKBservice manual download site
1 , why the projector without any reaction after power ?
A: Since the projector is plugged in, nothing happens , the power supply is part of the projector problems that may occur , but is inside the projector or external power supply problem? To do this , you should first check the projector's standard external power supply specifications are required with the same projector , say if the external power outlet is not grounded or projector using
The power cord is not random with the projector , which may have resulted in the projector's power input is not normal ; Once the external power supply is normal, you can conclude that the projector's internal power supply circuit is damaged , then you only have to replace the new the power supply inside the projector .
2, why would suddenly shut down the projector at work ?
A: If the projector is suddenly shut down , then there are two main reasons for the course of their work ; First, the user may accidentally cut off during operation of the power of the projector , so you should check first what is not human factors cause the projector off , after the exclusion of this case, it means the projector itself has a problem , and is likely to be caused by thermal protection . Because there are many high-end projectors in order to prolong the life of the projector , often using a self- heat protection, there is too much heat inside the projector generates encountered , working status of the projector will automatically work in this protected state , the projector will automatically shut off , and in this state , the projector for any external input control is not to make any response ; therefore this happens , you do not worry about the projector suddenly fails , you just automatically shut down the projector after about half an hour , and then follow the normal boot sequence to turn on the projector , you can let the projector to resume normal work.
4 1 2 3 4 Next Last |