|
After a period of time using the copier , paper conveyor belt due to high temperature baking and mechanical wear , reduce friction with the drive wheels , can not operate normally , often resulting in a jam. General repair methods , is a change over. But a set of four conveyor , generally about 120 dollars , the impact of copying costs. There are some experienced people can try the following method to repair .GMRservice manual download site
1 Open the copier front door , careful observation , if it is slippery due to the pollution caused by the toner , after a thorough clean, troubleshooting.
(2) If the conveyor belt is only a little wear and tear , can be hand carefully flip the inside and outside of each tape , increasing friction, failure can be ruled out .
3 If the tape is still intact, just a little longer. The method can replace the belt , remove the conveyor frame, put upside down and remove the eight white tensioner . The copy paper was cut into a 15 mm wide strip, and then folded into two stacked , folded width of 5 mm , a thickness of three sheets of paper strips, each pad is a tension wheel holder below ( preferably transparent tape fixed ) , and then as it is installed .
General repairs using the third method , can be printed 60000 ~ 80000 copy paper , than the new carousel at the store to buy supplies even durable.
|