|
Canon t11/20/22/30: This is Taiwan Campbell Canon oem product , so the operation is slightly different.
Cold start : Before powering Press the " Function" key to boot up after standby release. Press the " Function" key lookup service mode ;
Hot Start Method : In standby mode , followed by "functional " , " #" , " 7" , " 8" can be total clearance procedures .
Canon 270/450/490/750 etc. : The sw2 "ncu" on by a appropriated b, then press the "user data" "#"
Canon t800: followed by " data entry " button under the search key "set" "#" button on the search button "set"
Canon t550: followed by "functional " , " 4" and then use the search button to search until the "user data" and press the "start" "#"
Canon t40/50: The sw6 dial on the control board scnt to the "off" followed by "functional " "#" " any key " "set"
Canon t410: nomal switch ncu on the dial to test, the side of the memory allocated to off, press the "tti" "#" right direction , press any key 1-7
Canon b320: followed by "functional " "2" "start" "#" "start"
Canon b200, sw702: transferred from a to b followed by "functional " "2" "set" "#" "set"
Canon l250: followed by "functional " "<" "#"
|